2023 The best Heat Pump Installation

2023 The best Heat Pump Installation

How to install the air source pool heat pump ideally 100%? The regular use of thepoolheat pumpmust obeythe followingrules: unobstructed fresh air, power supply in line with the unit, and circulation flow in line with the unit.

The installation standards are as follows:

• 1. Thepoolheizungcan generally be arranged on the roof or on the ground near the building where thepool heateris used and should be kept away from places with dense crowds to prevent the impact of the airflow and noise of theheater's operation on the environment;
• 2. When theheat pump hasa side air inlet, the distance between the air inlet and the wall is not less than 1 meter, and when the twopool heat pumpsare arranged oppositely, the distance is not less than 1.5 meters;Heat Pump Installationin 2023
• 3. When thepool heat pumpis a top air outlet structure, theabove space ofthe outlet is not less than 2 meters;
• 4. Only one side of the wall around thepool heat pumpis allowed to be higher than the height of thepool heat pump;
• 5. The base height of thepool heatershould not be less than 300mm and greater than the local snow thickness;
• 6. Measures to remove a large amount of condensed water produced by thepool heat pumpshould be set up at the unit installation.

Parameter of the heat pump

Pool heat pump water system installation requirements

• 1. Install the air sourcepoolPool Heat Pumpdownstream of all filtration units and pool pumps, and upstream of all chlorine generators, ozone generators, and chemical disinfection. The inlet and outlet pipes can directly use PVC pipes;
• 2. Under normal circumstances, the air sourcepoolheat pump should be installed within 7.5 meters of the swimming pool, and if the swimming pool water pipe is too long, it is recommended to pack a 10mm thick insulation pipe, so as to avoid insufficient heating due to excessive heat loss of the unit;
• 3. The design of thepipelinesystem needs to install alooseconnection or flange on the inlet and outlet water of the heat pump for drainage in winter, and it can be used as an inspection port during maintenance;
• 4. Shorten the water pipeline as much as possible, avoid or reduce unnecessary pipeline changes to reduce the resistance loss, install the exhaust pipe at the highest position of the main pipeline toempty the air in the pipe; the lowest part of the system isrecommended toinstalladrain valve, just for thedraining of water when the system is cleaned.
• 5.Installa pool heat pump with the appropriate flow and head to ensure that the water flow meets the needs of thepool heat pump. In addition to the shock-proof soft joint connectionbetweenthe pump, the pool heat pump,and the pipeline, a supporting frameshould be provided to prevent the unit from being stressed.
• 6. TheALSAVO poolheatpumpis designed to withstand the water pressure of 0.4Mpa. To prevent damage to the heat exchanger, do not use overpressure.
• 7. During the operation of theALSAVO poolheat pump, the air temperature will decrease by about 5 degrees, and condensed water will be generated on the evaporator fins and fall on the chassis, and discharged through the plastic drain nozzle installed on the chassis. This is a normal phenomenon, and a drainage pipe must be installed to drain the condensed water.
• 8. Do not connect the tap water pipe or other water pipes to the circulation pipe, so as to avoid damage to the circulation pipe and thepoolheat pump.

For more information, welcome to visitpool heat pump manufacturer

Conclusions

The above suggestions are from the ALSAVO poolheat pump companies, ALSAVO pool heat pump is an innovative and high efficient pool heat pump with a good reputation for more than 15+ years. If there is any help we can do, please search the ALSAVO pool heat pump nearby and we are glad to be of some help.

Welcome to contact us at ALSAVO Heat Pump Companies